Powering a device with the car's battery
You can use your car's battery to power other electrical devices, such as electrical camping equipment, power tools and a variety of consumer devices. This feature is called Vehicle-to-Load1 and allows you to transfer AC power from your car to whatever you want to charge, as long as the other device is compatible.2
The energy transfer feature can be accessed in your car's charging settings. To be able to use the feature, you need a special V2L adaptor. Contact Polestar support for more information.
Important
Before you start using the transfer feature, there are some things to consider:
- Make sure you use a V2L adaptor from Polestar. Contact Polestar support for more information.
- Make sure you have read any available information about the V2L adaptor and device to be charged before you use this feature.
- Only use the V2L adaptor under safe conditions, avoiding rain, water or fire. Do not use the adaptor when it's wet.
- Prevent damage to the V2L adaptor in daily use by removing dust or other substances regularly. Make a habit of checking the adaptor for dust before using it.
- Do not submerge the V2L adaptor or its components in liquid. If you need to clean the adaptor, use a clean cloth lightly dampened with water. If needed, use a mild detergent but never use chemicals or strong solvents.
- Never use a damaged V2L adaptor. If the adaptor is found to be damaged, contact Polestar support.
To activate the transfer energy feature, make sure your car is in park, powered on and unlocked.
in the bottom bar and go to Charge.
to open the charge port.Note
You can set a transfer limit between 20-100%. The default transfer limit is 20%.
You can adjust the transfer limit at any time.
You can stop the transfer by pressing the power button on the adaptor or by pressing Stop transferring in the centre display.
Note
Recommended actions if a problem occurs during energy transfer
If a problem occurs, the transfer stops and the V2L adaptor unlocks from the charging port. An error status will be shown in the driver display and a fault message will be visible in the centre display.
- Disconnect any equipment connected to the V2L adaptor.
- Disconnect the V2L adaptor from your car.
- If possible, reduce the power needs from the connected device.
- Reconnect the V2L adaptor and the device, and start the transfer.
- If the problem persists, contact Polestar support.





