Inflating tires using the tire sealing system compressor
The vehicle's original tires can be inflated using the compressor in the tire sealing system.
The compressor must be switched off. Make sure that the switch is in the 0 (Off) position and take out the electrical cable and the hose.
Unscrew the tire's valve cap and screw the hose's valve connector as far as possible onto the valve.
Be sure the air release valve on the compressor's hose is completely closed.
Plug the electrical cable into the nearest 12 V outlet and make sure that the 12 V outlet is supplying electrical current.
Warning
Never leave children unattended in the vehicle while it is running.
Start the compressor by moving the switch to the I (On) position.
Important
To help avoid overheating, the compressor should never be used for more than 10 minutes at a time.
Inflate the tire to the pressure specified on the tire pressure decal on the driver's side door pillar. If the inflation pressure is too high, use the air release valve to release air.
Switch off the compressor. Remove the hose and the electrical cable.
Screw the valve cap back onto the tire.
Note
- After inflating a tire, always replace the valve cap to help prevent valve damage caused by gravel, dirt, etc.
- Only use plastic valve caps or original Polestar valve caps.
Note
The compressor is an electric device. Follow local regulations for disposal.