Installing child restraints on the front passenger seat
There are no anchorage points available for installing a child restraint on the front passenger seat.
Tip
- Only use child restraints that are recommended by Polestar, universally approved or are vehicle specific approved where the car is included in the manufacturer’s vehicle list.
- Retract the seat cushion extension and remove cushion extenders, leg supports and other accessories from the seat before installing a child restraint. If you use a kick guard accessory, this can remain on the seat.
- Any support legs of a child restraint should always be fitted directly to the floor. Do not fit support legs to any raised or uneven floor surfaces, footrests or other objects. Adjust the seat position if needed.
- Loose objects should not be stored around any support legs of a child restraint.
- When installing rearward-facing child restraints, adjust the seat to its lowest position.
- When installing adjustable, rearward-facing child restraints, adjust the child restraint according to the child’s age. Older children should be seated in a more upright position than younger ones.
- When installing a child restraint secured using the car's seatbelt or when the car's seatbelt is used to secure a child, ensure that brackets or other parts of the restraint do not come into contact with the seatbelt buckle button.
- When securing a child with the car's seatbelt, always start with the seatbelt's upper anchorage point adjusted to its highest level. Then lower it as needed to properly position the belt against the shoulder.
Warning
Passenger airbag status
- When installing rearward-facing child restraints, always check that the passenger airbag is disabled.
- When installing forward-facing child restraints, always check that the passenger airbag is enabled.
Failure to follow these instructions can endanger life or lead to serious injury.
Important
Note
Installation questions
If you have installation questions, contact the manufacturer of the child restraint for more detailed instructions.
Protecting the car interior
Be careful during installation to avoid damage to the car interior caused by protruding parts or sharp edges of the child restraint.
Fasten loose parts of child restraints, such as restraining straps, according to the manufacturer's instructions.
Important
General safety recommendations
When applicable, follow the general safety recommendations regarding seatbelt use, headrest adjustment and proper seating.
Local regulations
Regulations on where and how children should be seated and secured differ between regions. Make sure that you know what applies to the region you are in.