Stopping DC charging
You can stop the charging process at any time via the center display.
Important
Make sure to stop the charging session before attempting to unplug the cable from the vehicle's charging port. If you do not, you may cause damage to the cable or to the system.
Press Stop charging in the center display to stop charging.
The charging is stopped.
Unlock the charging cable using the handle on the cable.
Unplug the charging cable from the vehicle.
If available, reattach the protective cover on the cable connector.
Reattach the charging port's protective cover and then press Close charge port in the center display to close the charging lid.
Note
You can also close the charging lid by pressing the button located inside the port on the right side.
When the charging cable is unplugged from the vehicle, the lid will automatically close after a short period of time. If you start driving and the charging lid is open, it will close automatically.
However, there are also situations where the charging lid doesn’t close automatically. If you remove the charging cable but the vehicle is in sleep mode and no key is detected near the vehicle, the charging lid may stay open until the vehicle is woken up.
Tip
You can also stop the charging process via the charging station or from the Polestar app.
Recommended actions if the charging cable does not release
If the charging cable doesn't automatically release after you have stopped charging, there are some steps you can try.
Make sure that the key is within range and that the vehicle is unlocked.
- Carefully wiggle the charging cable.
- Lock and unlock the vehicle.
- Lock the vehicle and wait until the charging port light turns off. This can take some time. After that, unlock the vehicle and try to stop charging via the release button or via the center display again.
- If you're charging at a public charging station, follow the instructions in the charging station’s interface to release the charging cable.
- If the charging cable still doesn't release from the vehicle after you have stopped charging, you can use the emergency release handle. Never use the emergency release handle when charging is in progress.




