Replacing front wiper blade rubber
The service life of the front wiper blades' rubber is affected by the water, dirt and debris that they sweep off your windshield. You can replace the rubber when it shows signs of wear.
Activate the wiper service position via settings in the center display.
Lift the wipers up and away from the windshield.
Press the button on the wiper arm and pull the blade straight out so that it's parallel with the wiper arm.
Remove the end part of the blade. It's marked with the text Polestar. This is done by pushing the latch, located on the opposite side to the text, in the direction of the arrow.
You will hear a click when the lock is released.
Remove the rubber by pulling it out from the blade.
Insert the new rubber and reattach the end part of the blade.
You will hear a click when it locks in place.
Slide the blade back into the wiper arm until you hear it click into place.
Check that the blade is firmly attached.
Fold the wiper arms back down against the windshield.
Deactivate the wiper service position.