• Manual
  • Software updates

Using windscreen wipers

The windscreen wipers are designed to clean the windscreen. Different settings for the windscreen wipers are set using the right-hand stalk switch.
PS-2007-Windshield wipers and washers
Right-hand stalk switch.
  1. PS-Icon circle 1The thumbwheel is used to set rain sensor sensitivity and wiper swipe frequency.

Single sweep

PS-1926-Windshield Single sweep

Lower the stalk switch and release to make one sweep.

Windscreen wipers off

PS-1926-Windshield wiper off

Move the stalk switch to position 0 to switch off the windscreen wipers.

Intermittent wiping

PS-1926-Windshield, intermittent wiping

Move the lever up to switch the wipers to intermittent wiping. Set the number of sweeps per time unit with the thumbwheel when intermittent wiping is selected.

Continuous wiping

PS-1926-Windshield continuous wiping 1

Raise the stalk switch for the wipers to sweep at normal speed.

PS-1926-Windshield continuous wiping 2

Raise the stalk switch further for the wipers to sweep at high speed.


Before activating the wipers - ensure that the wiper blades are not frozen in, and that any snow or ice on the windscreen is scraped away.


Use plenty of washer fluid when the wipers are cleaning the windscreen. The windscreen must be wet when the windscreen wipers are operating.