Manual
Software updates

Using the rear-view mirror

You can adjust the rear-view mirror settings to suit your driving needs. Use the mode control switch on the bottom of the mirror to change between mirror modes.

The rear-view mirror has a mode control switch and three navigation buttons on the bottom of it. You can use the mode control switch to change between camera display mode and mirror mode. Use the navigation buttons to adjust the settings for the camera display mode.

You can manually move the rear-view mirror to suit your driving posture. However, this won't move the rear-view camera. You can adjust the rear-view camera height via the camera display mode settings.

 Important

Before driving, adjust both the mirror itself and the camera height to make sure that you can see the mirror well and have good visibility of what's behind you.

 Note

You might want to adjust the brightness level of the camera display mode in certain lighting conditions, such as strong sunlight.

Rear-view mirror controls

Locations of the mode control switch and navigation buttons
2
1
  1. 1Mode control switch
  2. 2Navigation buttons

Mode control switch

Change between camera display mode and mirror mode by moving the mode control switch. Push the switch towards the windscreen for mirror mode and pull the switch towards you for camera display mode.

Navigation buttons

Use the three buttons on the bottom of the mirror to navigate through the camera display mode settings. The buttons have different behaviours depending on which camera display mode settings view you are looking at. The three buttons are:
Stop buttonNavigate through the settings or confirm your adjustments.
Left arrowSelect the symbol currently highlighted in the mirror or adjust the selected setting.
Right arrowGo back or adjust the selected setting.

Camera display mode symbols

When the rear-view mirror is in camera display mode, you can see a number of different symbols in the mirror. These symbols include:
SettingsOpen the settings.
BrightnessUse the navigation buttons to adjust the mirror's brightness.
Camera heightUse the navigation buttons to adjust the camera height.
Camera tilt when reversingUse the navigation buttons to enable or disable the camera tilting when the car reverses.
Settings navigationNavigate through settings.
ConfirmConfirm your selection.
ErrorThe buttons are stuck, causing an error.

System faults

System faults can include problems with the rear-view mirror's display or the rear-view camera. If a problem with the system is detected, a fault symbol appears in the rear-view mirror. This symbol also indicates that the rear-view camera is disabled, which means that you won't be able to use the camera display mode.

You can reset the system by pressing and holding the stop button for approximately 10 seconds or by moving the mode control switch backwards and forwards until the camera display mode resets. If the reset doesn't work or if the problem persists, contact Polestar Customer Support for advice on repairs or replacement.

Related articles

    Polestar is operated in Hong Kong by Wearnes Motors