Auto-hold braking with speed-controlling functions
Braking function in slow traffic and at a standstill
In slow-moving, stop-and-go traffic or when stopped at a traffic light, driving will resume automatically if the vehicle is stopped for less than approx. 3 seconds. If it takes more than 3 seconds for the vehicle ahead to begin moving again, the driver support function will go into standby mode and the auto-hold brake function will activate.
- Pressing the
button on the steering wheel keypad. - Pressing the accelerator pedal.
Warning
steering wheel button. Warning
- Never wait for a warning or assistance. Apply the brakes when necessary.
Note
Driver support can keep the vehicle stationary for no more than 5 minutes – after that time the parking brake is applied and the function is deactivated.
The parking brake must be released before driver support can be reactivated.
Deactivation of the Auto-hold brake function
In certain situations, auto-hold will be deactivated when the vehicle is at a standstill and the function will go into standby mode. This means that the brakes will be released and the vehicle could begin to roll. The driver must actively apply the brakes to keep the vehicle stationary.
- The driver depresses the brake pedal.
- The parking brake is applied.
- The gear selector is moved to the N or R position.
- The driver puts Adaptive Cruise Control or Pilot Assist in standby mode.
Auto Activate Parking Brake
- The driver opens the door or unbuckles his/her seat belt.
- The function has kept the vehicle at a standstill for more than approx. 5 minutes.
- The brakes overheat.