• Manual
  • Video gallery
  • Software updates

Location and field of vision of Park Assist Cameras

The Park Assist Cameras (PAC1) can display a 360° panoramic view as well as separate views for each of the four cameras: rear, front, left and right. The cameras can be activated automatically or manually.

360° view

PS2-2007-Park Assist Camera 360-view
Camera buttons for each viewing direction. These buttons disappear after a moment if the screen is not touched.

The 360° view function activates all Park Assist Cameras and all four sides of the vehicle are shown in the center display at once to help the driver see what is around the vehicle while maneuvering at low speeds. From the 360° view, each camera view can be activated separately. Tap the screen to display the camera symbols and select the desired view.

Back

PS2-2007-Park Assist Camera placement rear
The rear camera is located above the license plate.

The rear camera shows a wide area behind the vehicle. Even part of the bumper may be visible.

Objects in the center display may appear to be leaning slightly. This is normal.

Front

PS2-2007-Park Assist Camera placement front
The front Park Assist Camera is located in the grille.

The front camera can be useful when pulling out from areas with limited visibility to the sides, e.g. when pulling out of a garage. The front camera is active at speeds up to 25 km/h (16 mph) and is automatically turned off when the vehicle exceeds this speed.

If the vehicle does not reach a speed of 50 km/h (30 mph) and speed falls below 22 km/h (14 mph) within 1 minute after the front camera turns off, the camera will be reactivated.

Sides

PS2-2007-Park Assist Camera placement outer side mirrors
The side cameras are located in the rearview mirrors.

The side cameras can show views along each side of the vehicle.

  1. 1 Park Assist Camera

Related articles