Performance software upgrade


When you install the performance software upgrade, the motor’s combined certified power output changes. You will then receive new bodyside graphics with updated power rating information, as well as a rank mark sticker for your car’s front grid. We’ve put together a list of instructions to help you disassemble your current decals and apply the new markings on your car in the best way possible.

When you install the performance software upgrade, the motor’s combined certified power output changes. You will then receive new bodyside graphics with updated power rating information, as well as a rank mark sticker for your car’s front grid. We’ve put together a list of instructions to help you disassemble your current decals and apply the new markings on your car in the best way possible.

Disassembly

1. Mark the position of the old graphic by placing a piece of masking tape at the top left, left side, and bottom edge of the old sticker on the door.
2. Apply hot air over the graphic with a hair dryer for 30 seconds. Lift the edge of the graphic and slowly peel it off.

Assembly

1. Clean the door surface where the graphic will be applied with the attached isopropyl-alcohol wet wipe.
2. Remove the protective foil from back of the graphic, starting on the left edge of the text. Do not peel completely in order to avoid touching the adhesive before applying.
3. Position one (1) door graphic on the door. Use the tape applied in step 1 of disassembly to line up the graphic correctly. Use a plastic scraping tool to apply the graphic slowly and carefully, beginning with the left edge of the text before going over the rest of the graphic, removing the remaining protective foil in the process. Be careful not to scratch the paint.
4. Remove the top-layer assembly foil (with holes) and the masking tape.
5. Clean the graphic assembly area on the door surface.

Try to not touch the adhesive layer on the graphic as this may cause loss of adhesion. The temperature on the door should be between 18–35°C.

1. Clean the surface of the square third from the right in the middle row on your car's front grid. Please use one of the isopropyl alcohol wet wipes.
2. Remove the protective foil from the back of the sticker.
3. Line up the sticker correctly and press it against the surface.

An even more responsive driving experience

Get the performance software upgrade as an over-the-air update

Read more about the upgrade
Polestar © 2022 All rights reserved
Change location: